SHOTGUN STANDARD DIVISION
Standard Division
|
1. |
Minimum Power Factor |
480 |
|
2. |
Minimum caliber |
20 gauge/bore |
|
3. |
Cartridge loops, clips or side-saddles fitted to the gun |
Yes |
|
4. |
Prototypes permitted |
No |
|
5. |
Complete shotgun produced by a factory (minimum 500 units) and available to the general public |
Yes |
|
6. |
Maximum overall length for gun |
Not applicable |
|
7. |
Compensators, ports, sound and/or flash suppressors permitted |
No |
|
8. |
External modifications such as weights, or external devices to control or reduce recoil (except for recoil pads fitted to the rear face of the stock of the shotgun) |
No |
|
9. |
Optical or Electronic sights |
No |
|
10. |
Aftermarket replacement open sights |
Yes |
|
11. |
Revolving or multiple magazine tubes |
No |
|
12. |
Capacity restrictions for initial load prior to the Start Signal |
Max. of 9 rounds loaded |
|
13. |
Detachable magazines |
No |
|
14. |
Speed loaders |
No |
|
15. |
Modifications/attachments to loading floor plate |
Yes, Restricted, see below |
|
16. |
Restriction on action types |
No |
Special conditions:
- Replacements of or modifications to elevators/floor plates, provided no part protrudes beyond the standard frame of the gun, are permitted.
- External feed ramps as direct replacements of the carrier release button (Remington 1100 and 1187 only) are permitted.