SHOTGUN MODIFIED DIVISION
Modified Division
|
1. |
Minimum Power Factor |
480 |
|
2. |
Minimum caliber |
20 gauge/bore |
|
3. |
Cartridge loops, clips or side-saddles fitted to the gun |
Yes |
|
4. |
Prototypes permitted |
Yes |
|
5. |
Complete shotgun produced by a factory (minimum 500 units) and available to the general public |
No |
|
6. |
Maximum overall length for gun |
1320 mm, see below |
|
7. |
Compensators, ports, sound and/or flash suppressors permitted |
Yes |
|
8. |
External modifications such as weights, or external devices to control or reduce recoil (except for recoil pads fitted to the rear face of the stock of the shotgun) |
No |
|
9. |
Optical or Electronic sights |
Yes |
|
10. |
Aftermarket replacement open sights |
Yes |
|
11. |
Revolving or multiple magazine tubes |
No |
|
12. |
Capacity restrictions for initial load prior to the Start Signal |
Max. of 14 rounds loaded |
|
13. |
Detachable magazines |
No |
|
14. |
Speed loaders |
No |
|
15. |
Modifications/attachments to loading floor plate |
Yes, Restricted, see below |
|
16. |
Restriction on action types |
No |
Special conditions:
- The unloaded gun, with its longest magazine fitted, and with its barrel parallel to the long edge, must fit wholly lengthwise into a rectangular box (open on one long side). The internal length of the box is 1320 mm (tolerance: +1 mm, -0 mm). The gun must not be artificially compressed in any way during the test. Additionally, telescoping magazines tubes must be fully extended.
- Modifications or attachments can be made or added to the loading floor plate to facilitate easier loading. Such modifications or attachments must not exceed 75 mm in length and must not protrude more than 32 mm from the standard frame of the shotgun in any direction.